In this video we show you how and where to create the mounting holes in BIt-zee's Lexan base for the arduino, batteries, camera, on/off switch and wire routing. Created by Karl Wendt.
Connecting LEDs to a power switch. Created by Karl Wendt.
Connecting the PDT switches. Created by Karl Wendt.
Creating motor mounts. Created by Karl Wendt.
The OER shares resources from Sussex University's Post-Punk Britain module. Students on the module work together with Technology Enhanced Learning at Sussex to produce their own OERs. We take the punk rock ethic (Do It Yourself, Do It Together, Keep It Simple, Make it Fast) challenge the role and place of history today and to break down the barriers between material and digital histories.
This video shows you how to "hotwire" a digital camera. This video outlines the first step in making our digital camera work in the Bit-zee robot. The required voltage for the camera was determined by adding the1.5 volt AAA batteries (there are three of them) together to get 4.5 volts (because the batteries are wired in series). Since new batteries usually have a voltage that exceeds their marked rating the camera can easily run on the 5 volts that the center terminal of our L298 motor controller provides. Created by Karl Wendt.
In this video we show you how to attach Bit-zee's camera and route the wires. Created by Karl Wendt.
In this video we attach and wire a digital voice recorder to Bit-zee. Created by Karl Wendt.
An introduction to the Spider bot. Created by Karl Wendt.
Adding grippy feet. Created by Karl Wendt.
In this video we connect, bend and wire Bit-zee's IR sensor. This sensor will allow Bit-zee to receive commands from a universal remote control. Created by Karl Wendt.
Activities, resources, photos and videos from ISKME's two day professional development teacher training that explores Open Educational Resources (OER) and Maker-Teacher collaborations to facilitate innovation in the classroom. The Makers’ projects are points of inspiration for Teachers while they engage in design-thinking activities to create, remix, and share OER Projects with online collaborative tools.
Installing a power switch. Created by Karl Wendt.
In this video we discuss some of the key parts of Bit-zee. Created by Karl Wendt.
In this video we create and wire Bit-zee's tri-color LED eyes. Created by Karl Wendt.
Learn how eclipses work by making your own with some clay, toothpicks, binder clips, a yardstick and don't forget the Sun!
In this video we take you step by step through building the L298 Motor driver. This controller allows you to use your Arduino to control the hair dryer motors used to move the Bit-zee bot. Created by Karl Wendt.
Connecting motors to the controller. Created by Karl Wendt.
In this video we show you how to attach and wire the L-298 motor controller board to Bit-zee's frame. Created by Karl Wendt.
In this video we show you how to determine which wire is which and how to connect them to your Arduino. Created by Karl Wendt.